SW2 L4-1.9L DOHC VIN 7 (1997)
- Torque: 27 N.m (20 ft-lbs)
3. Inspect spark plug wires. Replace any wire that is worn or chaffed.
NOTE: If boot is torn or ripped a new wire must be installed. Do not repair leads from which the terminals have been pulled off. Replace the lead.
4. Install spark plug wires. Press boots onto spark plugs until click is heard or felt.
NOTE: Install the spark plug wires on the correct spark plugs as indicated on each spark plug wire. Assure routing of wire on engine is away from
moving parts and exhaust.
NOTE: Orientation of the wires to the EIS module is critical to the operation of both the module and on-board diagnostics. The orientation is 4 1
2 3 respectively from left to right.
