SW2 L4-1.9L DOHC VIN 7 (1997)
8. Remove and discard lower control arm ball stud cotter pin.
9. Loosen ball stud castle nut, until top of castle nut is level with top of ball stud.
10. Remove and discard tie rod cotter pin.
11. Remove tie rod end castle nut.
NOTICE: On ABS equipped vehicles, the outer CV joint has a speed sensor ring. Using the incorrect tool or procedure to separate the control
arm from the knuckle can damage the ring, resulting in a loss of ABS operation.
NOTICE: Do not attempt to separate the joint using a wedge-type tool because the seal may be damaged.
12. Using SA9132S (or equivalent), separate lower control arm from steering knuckle.
NOTICE: Lubricate threads of tool forcing screw using thread lube with each use.
