SW2 L4-1.9L DOHC VIN 7 (1997)
2. Remove insulation from the end of the cut lead and the harness. Recommend strip length is 9.5 mm (3/8 in.). Caution must be used to prevent
cutting the wire strands.
Push-To-Seat Connectors: Wire Size
3. Determine proper sleeve for gage of wire.
Push-To-Seat Connectors
4. Position stripped ends in sleeve until wires hit the stop in the center of the splice.
5. Hand crimp using the approved crimping tool. Gently tug on wires to make sure they are secure before applying heat to them.
CAUTION: Do not use match or open flame to apply heat to seal.
6. Apply heat using Ultratorch(R) or some other device, heating to 175 °C (347 °F) until glue flows around edge of sleeve.
7. Check for continuity.
8. Insert the terminal into the connector. Check to make sure the terminal lock tab is engaged by gently tugging on the wire.
9. Replace any terminal position assurance (TPA) devices.
IMPORTANT: The salmon splice can be used on the 0.35 (22 gage) wire if the following additional steps are taken:
10. Remove 19 mm (3/4 in.) of insulation.
11. Bend the stripped portion in half to double the thickness.
12. Twist the stripped, doubled wire and insert into the splice sleeve.
Pull-to-Seat Connectors
