SW2 L4-1.9L DOHC VIN 7 (1997)
Engine Control Module: Service and Repair
Powertrain Control Module (PCM) Replacement
NOTE: Record preset radio stations and clock time. Disconnect negative battery cable.
REMOVAL
1. Remove I/P upper trim panel outer cover fillers by carefully lifting up at clip locations, starting at the rear above end cap.
I/P Retaining Bolt Caps
2. Remove I/P bolt caps by carefully prying with a small flat head screwdriver.
3. Remove I/P upper trim panel screws.
Upper Trim Panel Removal
4. Lift I/P upper trim panel at clip locations on rear edge to disengage clips.
5. Pull I/P upper trim panel rearward out of clips at bottom of windshield.
NOTE: Be careful, when removing or replacing I/P upper trim panel, not to damage VIN plate.
6. Remove I/P upper trim panel.
NOTE: Be careful, when removing upper trim panel, not to damage the upper trim panel seal (SL/SW only).