SW2 L4-1.9L DOHC VIN 7 (1997)
8.
Using a DVOM and connector test adapter kit SA9206Z, measure resistance of fuel level sender at fuel pump module connector terminals "B" and
"C" While measuring resistance, move tank to "slosh" fuel.
^
If resistance fluctuates between approximately 677 and 440 ohms, float level is correct and fuel tank can be reinstalled in vehicle. Refer to
"Fuel Tank" section of the appropriate model year Engine/Fuel/Air Intake/Exhaust Service Manual.
^
If resistance remains at approximately 440 or fewer ohms, fuel pump module must be removed and float level increased by 1.6 mm (1/16 in.).
Continue to increase float level by 1.6 mm (1/16 in.) increments until resistance fluctuates between approximately 677 and 440 ohms when
fuel is "sloshed."
^
If resistance remains at 677 when the fuel is "sloshed," the float arm is adjusted too high as measured on the bench and must be adjusted back
down.
9.
After installing fuel tank in vehicle, verify that low fuel lamp illuminates with less than 1.5 gallons (5.7 L) of fuel in tank.
