SW2 L4-1.9L DOHC VIN 7 (1997)
1.
Connect rear compartment lock cylinder rod to clip on rear compartment lock cylinder.
2.
Install rear compartment lock cylinder to rear compartment lid.
3.
Install rear compartment lid lock cylinder retainer to rear compartment lock cylinder.
4.
Verify that rear compartment lock cylinder operates correctly.
5.
Install rear compartment lid outer lower panel. (Refer to "Compartment Lid Outer Panel" procedure for Sedan or "Rear Compartment Lid Outer
Panel" for Coupe, in the "Rear End" section of the "1997 Body/Repair Service Manual.")
Ignition Lock Cylinder Installation - All Vehicles
IMPORTANT:
Ignition lock cylinder actuator blade within ignition lock cylinder module must be in the ACC position to install ignition lock cylinder assembly. If
rotated, align ignition lock cylinder actuator blade with step as shown in illustration.
