SW2 L4-1.9L DOHC VIN 7 (1997)
Spark Plug: Service and Repair
Spark Plugs and Wires
Plug Wire Routing - DOHC
Coil Wire Connections At Spark Plugs
SPARK PLUGS AND WIRES
NOTE: Before removing the spark plugs make sure water and other debris in the spark plug wells are blown out.
NOTE: Do not use a flexible extension socket to remove spark plugs. Damage could occur to the spark plug insulator.
NOTE: Use only a spark plug socket that has a rubber insert to hold the spark plug in place.
REMOVAL
1. Gently pull spark plug boots off of spark plugs. Twist boot during removal to break any bonding.
2. Remove spark plugs.
INSTALLATION
NOTE: Make sure the gasket is on the spark plug.
NOTE: Do not bend over the electrodes on the spark plugs after removal. Spark plugs sent back for analysis must be in the original condition after
removal from the engine.
1. Set gap on spark plugs to 1.51 mm (0.040 in).
2. Install spark plugs.