SW2 L4-1.9L DOHC VIN 7 (1997)
5.
Measure float level by standing fuel pump module on a flat, horizontal surface and measure distance from this surface to bottom of float. A 4 mm
(5/32 in.) diameter drill bit can be used as a gauge. The gauge must freely pass between float and horizontal surface with no more than 1.6 mm
(1/16 in.) of clearance.
NOTICE:
If float arm requires repositioning to meet clearance specification, ensure that any bending is performed at 90 degree bend near fuel level sender. The
short section of float arm going into fuel level sender must be supported to avoid bending the fuel level sender.
^
If float level is less than 4 mm (5/32 in.) adjust float level to 4 mm (5/32 in.).
^
If the float level was at 4 mm (5/32 in.) or greater, increase float level by 1.6 mm (1/16 in.).
6.
Install fuel pump module into the fuel tank. Refer to the "Fuel Pump Module" section of the appropriate model year Engine/Fuel/Air
Intake/Exhaust Service Manual.
7.
Place fuel tank on a flat, horizontal surface and fill 1.5 gallons (5.7 L) of fuel in tank.
