SW2 L4-1.9L DOHC VIN 7 (1997)
Brake Light Switch: Adjustments
1. Loosen the stop lamp switch mounting nut sufficiently to allow the switch to move forward and rearward in the adjustment slot.
2. Install stop lamp switch adjustment gage (SA 9303BR) between the switch and the switch actuator pad on the brake pedal arm being sure that the
plunger protrudes through the slot in the gage.
3. While pulling up with moderate force on the brake pedal assembly, push the switch forward against the gage.
CAUTION: Hold the switch perpendicular to the actuator pad on the brake pedal arm to prevent the switch from rotating out of alignment when
tightening the mounting nut.
4. Tighten the switch mounting nut.
^
Torque to 1O Nm (89 inch lbs.)
5. Release the brake pedal assembly.
6. With the pedal released and the adjustment gage still in position, tap the gage side-to-side:
a. If the gage swings freely side-to-side, proceed to Step 7.
b. If the gage sticks or does not swing freely, repeat Steps 1 through 6.
