SW2 L4-1.9L DOHC VIN 7 (1997)
Horn Switch: Testing and Inspection
Circuit Operation
Lever Combination Switch (LCS)
The Lever Combination Switch (LCS) operates the headlamps, turn lamps, hazard lamps, and front and rear wipers. The LCS also provides a circuit path
to the cruise control switch, horn switches, and the driver air bag.
The following charts can be used as a system check for the headlamp, turn/hazard. cruise, horn, front and rear wiper switches, and driver air bag.
Connected Symbol
This symbol indicates that the circuits referenced are connected (less than one ohm resistance) when the switches are in the position indicated in the
columns on the left side of each chart.
Resistance Symbol
The symbol, for the wiper switch, represents resistance between the two connector cavities joined by the circles. Resistance values are listed in the
columns on the right side of the chart. Resistance measurements should be within + 10 percent of the resistance values shown.
When performing system checks, the Saturn Connector Test Adapter Kit SA9206Z should be used.
