SW2 L4-1.9L DOHC VIN 7 (1997)
3.
Rotate ignition lock cylinder and install ignition lock pin spring and ignition lock cylinder pin.
4.
Remove ignition key and install ignition and start switch bezel to ignition lock cylinder assembly.
5.
Verify that ignition lock cylinder operates correctly.
a.
Insert ignition key into ignition lock cylinder.
b.
Turn ignition key to the RUN position.
c.
With ignition key in RUN position, pull on ignition key using the same force that would be used to remove the ignition key while in the
LOCK position.
^
If ignition key cannot be removed entirely from ignition lock cylinder, proceed to step 6.
^
If ignition key can be removed entirely from the ignition lock cylinder, check ignition lock cylinder and correctly code the lock cylinder. If
ignition lock cylinder was coded incorrectly, check coding on the front side door lock cylinder, and the rear compartment or liftgate lock
cylinder.
IMPORTANT:
The ignition key may have some movement. However, this is normal, and it is operating correctly as long as the key cannot be removed entirely from
the ignition cylinder.
6.
To install ignition lock cylinder assembly, refer to "Ignition Lock Cylinder Installation - All Vehicles" in "Lock Cylinder Installation Procedures"
included in this bulletin.
Front Side Door Lock Cylinder Assembly - All Vehicles
