SW2 L4-1.9L DOHC VIN 7 (1997)
2.
Remove lock cylinder pawl.
3.
Remove lock cylinder spring.
4.
Insert a thin-bladed screwdriver between lock cylinder cap and lock cylinder housing, and carefully pry lock cylinder cap from lock cylinder.
IMPORTANT:
When lock cylinder cap shutter is removed, the lock cylinder shutter springs may fall out.
5.
Remove lock cylinder cap shutter and shutter springs from lock cylinder housing.
6.
Insert key into lock cylinder, turn the key a quarter turn clockwise, and slide lock cylinder from lock cylinder housing.
7.
To code liftgate and rear compartment lock cylinders, refer to "Lock Cylinder Coding Procedures - All Lock Cylinders" included in this bulletin.
Ignition Lock Cylinder Disassembly
1.
Remove ignition key from ignition lock cylinder.
2.
Using a thin-bladed screwdriver, remove ignition and start switch bezel from ignition lock cylinder housing.
