SW2 L4-1.9L DOHC VIN 7 (1997)
Starter Assembly Removal
4. Remove the two starter assembly-to-engine block bolts.
5. Pull the starter rearward toward the left-hand side of vehicle for removal.
Starter Assembly Removal
INSTALLATION
1. Guide the starter into the flywheel housing and rotate the assembly until the lower bolt hole in the starter nose aligns.
2. Loosely install the lower starter housing-to-engine block bolt.
3. Install the upper starter housing-to-engine block attachment bolt.
Starter Assembly Bolts:
Torque: 37 N^m (27 ft-lbs)
4. Tighten both upper and lower attachment bolts and torque.
NOTE: Do not over torque the starter solenoid electrical connection nuts. Over torquing will crack the solenoid's phenolic end cap, allowing
debris and moisture to corrode the electrical contacts.
5. Install solenoid ignition wire (small purple wire).
