SW2 L4-1.9L DOHC VIN 7 (1997)
2. Install steering gear-to-cradle bolts and new nuts.
-
Torque: 50 Nm (37 ft. lbs.)
3. Install intermediate shaft onto the steering gear and torque pinch bolt.
-
Torque: 47 Nm (35 ft. lbs.)
IMPORTANT: Use Loctite(r) 242 Threadlocker (or equivalent) on thread of pinch bolt.
4. Install left side splash shield.
IMPORTANT: Install rear section of shield first, then front
5. Install tabs in body cut-out.
6. Align molded-in shield fasteners with holes in cradle. Push straight in to install.
7. Install push pins.
IMPORTANT: Make sure shield flaps are tucked in at body locations.
