SW2 L4-1.9L DOHC VIN 7 (1997)
stud. Do not lubricate the smooth tapered portion of the stud.
9. Install tie rod ends into steering knuckles. Torque castle nut.
-
Torque: 45 Nm (33 ft. lbs.)
IMPORTANT: If it is necessary to rotate the castle nut after tightening to orient it to the hole in the stud, always tighten the nut to align it; never
loosen it.
10. Install new cotter pins into castle nuts.
11. Connect negative battery cable.
-
Torque: 17 Nm (151 inch lbs.)
NOTICE: Before installing wheels remove rust or corrosion from wheel mounting surfaces and brake rotors/drums. Failure to do so can cause
wheel lug nuts to loosen in service.
12. Position wheel onto hub.
13. Install wheel nuts and tighten in a crisscross pattern. Repeat tightening pattern to make sure torque is correct.
-
Torque: 140 Nm (103 ft. lbs.)
14. Set toe. (Refer to Alignment.)
15. Bleed power steering system. (Refer to "Power Steering Bleed Procedure.")
