SW2 L4-1.9L DOHC VIN 7 (1997)
13. Remove lower control arm ball stud castle nut.
NOTICE: Do not attempt to separate the joint using a wedge-type tool because the seal may be damaged.
14. Using SA91100C (or equivalent), separate tie rod end from steering knuckle.
15. If equipped with ABS, disconnect electrical connector at ABS wheel speed sensor.
16. Support or suspend drive axle assembly.
17. Remove the two strut-to-steering knuckle fasteners.
NOTICE: Never pull on the shaft assembly.
18. Remove the knuckle/wheel hub assembly from vehicle.
