SW2 L4-1.9L DOHC VIN 7 (1997)
NOTICE: On ABS equipped vehicles, the cuter CV joint has a speed sensor ring. Using the incorrect tool or procedure to separate the control
arm from the knuckle can damage the ring, resulting in loss of ABS operation.
NOTICE: Do not attempt to separate joint using a wedge type tool because the seal may be damaged.
6. Separate ball joint from steering knuckle using SA9132S and remove nut.
7. Remove left inner splash shield.
8. Separate axle from transaxle using a large screw driver or appropriate pry bar and tie-up shaft with safety wire.
9. Remove the snap ring retaining the axle seal.
10. Remove axle seal using SA9133T.
a. Remove dust cover by prying out with a screw driver.
b. Remove seal by threading puller through steel portion of the seal body as close to outside diameter as possible.
