SW2 L4-1.9L DOHC VIN 7 (1997)
INSTALLATION
1. Clean seal bore in housing.
2. Apply a light bead of Loctite(r) 515 Gasket Eliminator sealant (P/N 21005993) or equivalent on the diameter of the seal that presses into the
converter housing bore.
NOTICE: Prior to using seal installer SA9113T inspect the tool for any nicks or burrs that may damage the seal lip.
3. Use tool SA9113T to install seal. Place seal on tool and be sure to keep seal lined up with bore during installation.
4. Install flywheel dust cover if removed.
-
Torque: 11 N.m (97 inch lbs.).
5. Install powertrain stiffening bracket and install bracket to engine, and bracket to transaxle bolts.
-
Torque: 54 N.m (40 ft. lbs.).
NOTICE: Use caution not to damage axle seal when intermediate shaft is installed into transaxle.
6. Install axle seal protector tool SA91112T inside seal. (Left side shown, right side similar.)