SW2 L4-1.9L DOHC VIN 7 (1997)
5. Adjust Park/Neutral switch before tightening PNP switch to case bolts.
ADJUST AND FINALIZE INSTALLATION
Ohmmeter Hook-up
1. Place transaxle in D (Drive). Use ohmmeter or continuity tester to check for continuity across terminals on switch. Loosen the mounting bolts and
rotate the park neutral position switch from the left front fender towards the engine until continuity is achieved.
2. Tighten switch to case bolts. After switch to case bolts have been tightened, check continuity.
- Torque: 14 N.m (124 in-lbs)
NOTE: DVM with audible continuity test is preferred. Do not stick probe in terminal hole; use male terminals on switch or faulty readings could
exist.
NOTE: While adjusting the park neutral position switch, always rotate the switch towards the engine to achieve continuity. A DTC P0706 could
result if this procedure is not followed.
3. Connect electrical connectors.
Air Induction System
4. Install air induction system.
- Torque: 10 N.m (89 in-lbs)
