SW2 L4-1.9L DOHC VIN 7 (1997)
8. Separate carpeting at front of dash under control cable assembly.
IMPORTANT: Carpet is held together by Velcro(R) tape.
9. Remove the retainers, on both sides of the cable pass-through opening, holding the sound deadening material.
10. Roll back the sound deadening material at the front of dash to gain access to the cable pass through grommet.
11. Place a large flat blade screwdriver against the driver's side of the cable pass through grommet as shown.
12. Push the grommet toward the passenger side of the vehicle and outward to disengage the grommet from the floor pan.
NOTICE: There is an extra retaining tab on the passenger side of the cable pass-through grommet. Removing the grommet passenger side first
may cause damage to the floor pan.
CAUTION: MAKE SURE VEHICLE IS PROPERLY SUPPORTED AND SQUARELY POSITIONED. TO HELP AVOID PERSONAL
INJURY WHEN A VEHICLE IS ON A HOIST, PROVIDE ADDITIONAL SUPPORT FOR THE VEHICLE ON THE OPPOSITE END
FROM WHICH COMPONENTS ARE BEING REMOVED.
13. Lift vehicle.
14. Remove the control cable and cable pass-through grommet from the outside of the vehicle.
IMPORTANT: When removing and installing control cables it is helpful to have a second person inside the vehicle to guide the cables and