SW2 L4-1.9L DOHC VIN 7 (1997)
4. Loosen the two engine strut bracket-to-cradle fasteners to remove any fore/aft preload from the engine strut.
5. Tighten the engine strut bracket-to-cradle fasteners.
-
Torque: 50 Nm (37 ft. lbs.)
6. Install the left side splash shield.
IMPORTANT: Install rear section of shield first, then front
7. Install tabs in body cut-out.
8. Align molded-in shield fasteners with holes in cradle. Push straight in to install.
9. Install push pins.
IMPORTANT: Make sure shield flaps are tucked in at body locations.
NOTICE: Before installing wheels, remove rust or corrosion from wheel mounting surfaces and brake rotors/drums. Failure to do so can cause
wheel lug nuts to loosen in service.
10. Position the left front wheel onto the hub.
11. Install the wheel nuts and tighten in a crisscross pattern. Repeat tightening pattern to be sure torque is correct.
-
Torque: 140 Nm (103 ft. lbs.)
12. Lower vehicle from hoist.