SW2 L4-1.9L DOHC VIN 7 (1997)
3. Install the air box with three fasteners.
-
Torque: 10 Nm (89 inch lbs.)
4. Install resonator and secure with plastic push-pin.
5. Connect electrical connector at the intake air temperature (IAT) sensor.
6. Install air cleaner housing cover and clean air inlet tube.
7. Connect fresh air hose at cam cover.
8. Secure clamp at throttle body assembly.
CAUTION: MAKE SURE VEHICLE IS PROPERLY SUPPORTED AND SQUARELY POSITIONED ON HOIST. TO HELP AVOID
PERSONAL INJURY, PROVIDE ADDITIONAL SUPPORT TO THE OPPOSITE END OF THE VEHICLE THAT COMPONENTS
WILL BE REMOVED FROM.
9. Raise vehicle on a hoist.
10. Loosen the two engine strut bracket-to-cradle fasteners to remove any fore/aft preload from the engine strut.
11. Tighten the engine strut bracket-to-cradle fasteners.
-
Torque: 50 Nm (37 ft. lbs.)
12. Lower vehicle from the hoist.
