SW2 L4-1.9L DOHC VIN 7 (1997)
Transmission Speed Sensor: Service and Repair
Turbine Shaft Speed Sensor Replacement
REMOVAL
1. Position vehicle on lift and raise vehicle.
2. Disconnect electrical connector from Turbine Shaft Speed (TSS) sensor and remove sensor.
IMPORTANT: Inspect O-ring for damage and replace if necessary.
INSTALLATION
1. Install TSS sensor.
-
Torque: 26 N.m (19 ft. lbs.).
IMPORTANT: Clean and lubricate fastener with Transaxle Fluid. Wipe off excess fluid and install.
2. Connect electrical connector to TSS sensor. Push in until a click is heard and pull back on connector to confirm positive engagement.
3. Lower vehicle.
4. Check transaxle fluid level.
