SW2 L4-1.9L DOHC VIN 7 (1997)
Clutch Master Cylinder: Service and Repair
Hydraulic Clutch Control System
IMPORTANT: The clutch hydraulic system is to be serviced as a COMPLETE UNIT!!!. It is a sealed unit and has been filled with fluid and bled of
air at the factory. Individual components of the system are not available for service, except the slave cylinder actuator pushrod plastic retainer strap. Do
not attempt to bleed the clutch hydraulic system. The bleed screw located on the clutch hydraulic slave cylinder is used for the factory fluid fill only.
WARNING: Do not attempt to bleed the clutch hydraulic unit. Any observed fittings are there for factory use only. The unit comes as a
complete pre-bled unit.
REMOVAL
1. Block clutch pedal up to prevent pedal from being depressed with slave cylinder removed from transaxle.
2. Remove air induction system.
