SW2 L4-1.9L DOHC VIN 7 (1997)
IMPORTANT: If it is necessary to rotate the castle nut after tightening to orient it to the hole in the stud, always tighten the nut to align it; never
loosen it.
7. Install rotor onto wheel hub.
8. Install caliper mount bracket onto knuckle.
-
Torque: 110 Nm (81 ft. lbs.)
9. If equipped with ABS, install electrical connector to ABS wheel speed sensor.
10. Depress brake pedal and tighten axle to hub nut.
-
Torque: 200 Nm (148 ft. lbs.)
NOTICE: Before installing wheels, remove rust or corrosion from wheel mounting surfaces and brake rotors/drums. Failure to do so can cause
wheel lug nuts to loosen in service.
11. Position wheel onto hub.
12. Install wheel nuts and tighten in a crisscross pattern. Repeat tightening pattern to make sure torque is correct.
-
Torque: 140 Nm (103 ft. lbs.)
13. Lower vehicle from hoist.
14. Perform vehicle wheel alignment.
