SW2 L4-1.9L DOHC VIN 7 (1997)
NOTICE: On ABS equipped vehicles, the outer CV joint has a speed sensor ring. Using the incorrect tool or procedure to separate the control
arm from the knuckle can damage the ring, resulting in a loss of ABS operation.
NOTICE: Do not attempt to separate the joint using a wedge type tool because the seal may be damaged.
6. Separate ball joint from steering knuckle using SA9132S and remove nut.
NOTICE: Do not attempt to separate the joint using a wedge Ape tool because the seal may be damaged.
7. Separate the tie rod end from the knuckle.
a. Remove cotter pin and discard.
b. Remove nut.
c. Separate tie rod end from knuckle using tie rod end separating tool SA91100C.
8. Remove left inner splash shield.
