SW2 L4-1.9L DOHC VIN 7 (1997)
7.
Install high mount stop lamp assembly and high mount stop lamp assembly screws.
Torque: 2.5 Nm (19 in-lbs)
8.
Connect high mount stop lamp electrical connector.
9.
Position liftgate window upper garnish molding to vehicle. Align clip locations and snap clips into place.
10.
Install two liftgate trim retainers into ends of liftgate window upper garnish molding.
11.
Close rear liftgate and verify that condition has been repaired.
PARTS REQUIREMENTS:
15739432
Bumper - Rear/Door
CLAIM INFORMATION:
To receive credit for this repair during the warranty coverage period, submit a claim through the Saturn Dealer System using the appropriate Electronic
Labor Time Guide and Labor Operation Code N1600 (Replace Center High Level Stop Lamp Assembly).