VUE 2WD L4-2.2L VIN D (2005)
Stabilizer Bushing: Service and Repair
Front
Stabilizer Shaft Insulator Replacement
Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the stabilizer bar clamp to cradle bolts.
3. Remove the stabilizer bar clamps and bushings from the stabilizer bar.
Installation Procedure
1. Install the stabilizer bar clamps and bushings to the stabilizer bar.
2. Notice: Refer to Fastener Notice in Service Precautions.
Install the stabilizer bar clamp to cradle bolts.
^
Tighten the bolts to 50 Nm (37 ft. lbs.).
3. Lower the vehicle.