VUE AWD L4-2.2L VIN D (2005)
4. Connect the ball joint stud to the steering knuckle.
Notice: Refer to Fastener Notice in Cautions and Notices.
5. Using the SA9140E , install the ball stud castle nut.
Tighten the nut to 10 N.m (89 lb in) + 180 degrees.
Important:
*
Do not loosen the castle nut in order to align the cotter pin slots.
*
Ensure the cutter pin ends do not contact the wheel speed sensor harness.
6. Continue to tighten the castle nut to align the slots with the opening in the ball stud and install the ball stud cotter pin.
7. Remove the mechanics wire and install the steering gear to the frame.
Tighten the bolts to 110 N.m (81 lb ft).
