VUE AWD L4-2.2L VIN D (2005)
Caution: Striking the vehicle near the side air bag impact sensor can cause an air bag deployment if the ignition switch is not OFF. To help avoid
personal injury and damage to the vehicle from a deployment. Always turn the ignition switch OFF during body repairs.
1. Position the molding to the frame.
2. Push at the clip locations to secure the attaching clips.
3. Position the weatherstrip over the edge of the garnish molding.
4. Install the hinge pillar garnish molding.
5. Install the rear carpet retainer. Refer to Carpet Retainer Replacement - Rear (See: Carpet/Service and Repair/Removal and Replacement/Carpet
Retainer Replacement - Rear) .
6. Install the center pillar upper molding. Refer to Garnish Molding Replacement - Center Pillar Upper (See: Garnish Molding Replacement - Center
Pillar Upper) .
7. Position the weatherstrip over all of the moldings.
8. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 2 and to SIR Disabling and Enabling Zone 6 in SIR.
Garnish Molding Replacement - Center Pillar Upper
Garnish Molding Replacement - Center Pillar Upper
