VUE AWD L4-2.2L VIN D (2005)
9. Install the thermostat housing to block seal onto the thermostat housing, if damaged.
10. Install the water feed pipe into the water pump assembly.
11. Align the water feed pipe to the thermostat housing assembly.
12. Seat the water feed O-ring seal by pushing and twisting toward the water pump. Take care not to tear or damage the O-ring.
13. The water feed pipe has a locating tab to assure proper alignment.
14. Position the thermostat housing against the engine. Be sure that the thermostat housing pipe is properly positioned against the support bracket near
the front of the engine.
15. Install the thermostat housing to block bolts.
Tighten the thermostat housing-to-block bolts to 10 Nm (89 inch lbs.).
16. Connect the electrical connector to coolant temperature sensor.
17. Install the right hand inner splash shield and push pins.
18. Install the right hand tire assembly and wheel nuts.
Tighten the wheel nuts to 125 Nm (92 ft. lbs.).
19. Lower the vehicle.
20. Install the thermostat pipe bracket to cylinder head bolt.
Tighten the thermostat pipe bracket-to-cylinder head bolt to 8 Nm (71 inch lbs.).
