VUE AWD L4-2.2L VIN D (2005)
6. Install the HVAC module seal nuts to the front of dash. Draw the HVAC module to the front of dash evenly by alternating between the seal nuts.
Tighten the nuts to 8 N.m (71 lb in).
IMPORTANT: New front of dash seal nuts must be used to prevent leaks.
7. Install the HVAC module bolts to the right side of the cross car beam.
8. Push up on the right side of the HVAC module while tightening the HVAC module bolts to the cross car beam.
Tighten the bolts to 8 N.m (71 lb in).
9. Install the HVAC module bolt to the left side of the cross car beam.
Tighten the bolt to 8 N.m (71 lb in).
10. Install the HVAC module nuts to the left side and center of the cross car beam.
Tighten the nuts to 8 N.m (71 lb in).
