VUE AWD L4-2.2L VIN D (2005)
2.
Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in SI. 2007 Saturn Model shown.
Tip
The DRL resistor (1) is located on the left front bumper support and may require cleaning before inspection.
3.
For Chevrolet and Pontiac models, loosen the left front corner of the inner wheel liner to front fascia to gain access to the DRL resistor. Refer to
Front Wheelhouse Liner Replacement in SI. Saturn models do not require the removal of the left front wheel or inner wheel liner to gain access to
the DRL resistor (1). Proceed to Step 4.
4.
Use a mirror and light to visually inspect the daytime running lamps resistor for cracks or corrosion.
1.
If the resistor is cracked or corroded, remove the resistor. Refer to Daytime Running Lamps (DRL) Resistor Replacement in SI. Proceed to
Step 5.
2.
If the resistor appears to be in good condition, follow normal SI diagnostics.
^
If DTC B2600 is set, refer to DTC B2600 in SI.
^
If no codes were set, refer to Daytime Running Lamps (DRL) Inoperative in SI.
5.
Install the new DRL resistor assembly to the left front bumper support with the washer (1) between the resistor and bumper support.
6.
Tighten the new DRL resistor bolt.
Tighten
Tighten the bolt to 6 N.m (53 lb in). DO NOT EXCEED 6 N.m (53 lb in).
7.
Connect the DRL electrical connector to the DRL resistor.
8.
For Chevrolet and Pontiac models, install the left front corner of the inner wheel liner to front fascia. Refer to Front Wheelhouse Liner
Replacement in SI. Saturn models did not require the inner wheel liner to be removed. Proceed to Step 9.
9.
Lower the vehicle and unhoist.
10.
Clear any DTCs and verify the operation of the daytime running lamps.
Parts Information
Warranty Information
