VUE AWD L4-2.2L VIN D (2005)
5. Important: After adjusting the switch, verify the engine only starts in Park or Neutral. If the engine starts in any other position, adjust the switch.
Insert the J 41545 as shown and rotate the PNP switch until the tool drops onto position.
6. Notice: Tighten the PNP switch bolt and stud.
Tighten the bolt and stud to 20 Nm (15 ft. lbs.).
7. Remove the alignment tool.
8. Install the transaxle range select lever (3) to the transaxle manual shaft (1).
9. Install the transaxle range select lever nut (2).
^
Tighten the nut to 35 Nm (26 ft. lbs.).
10. Install the shift control cable and retaining clip (2) to the shift control cable bracket (1).
11. Install the shift control cable (3) to the range select lever (4).
12. Verify proper operation of the shift control cable and if necessary adjust the cable.
1. Place the shift lever in N (Neutral). Rotate the selector shaft clockwise from P (Park) through R (Reverse) into N (Neutral).
2. With the shift control assembly in N (Neutral) lift the cable connector locking clip up.
3. Push the clip on the cable connector until fully seated and flush with cable body.
Installation Procedure (New Switch)
