VUE AWD L4-2.2L VIN D (2005)
1. Important: After adjusting the switch, verify the engine only starts in Park or Neutral. If the engine starts in any other position, adjust the switch.
Make sure the transaxle manual shaft is in the Neutral position.
2. Align the flats on the PNP switch with the transaxle manual shaft and install the PNP switch.
3. Notice: Install the PNP switch bolt (2) and stud (1).
Tighten the bolt and stud to 20 Nm (15 ft. lbs.).
4. Connect the PNP switch electrical connector (3).
5. Install the transaxle range select lever (3) to the transaxle manual shaft (1).
6. Install the transaxle range select lever nut (2).
^
Tighten the nut to 35 Nm (26 ft. lbs.).
