VUE AWD L4-2.2L VIN D (2005)
1. Make sure the lines are not kinked, bent, or damaged.
NOTE: Fuel/Vapor lines cannot be spliced or repaired. The line must be replaced (if damaged) with the same type of line.
2. Install the fuel and EVAP lines into underbody retainers. Make sure the lines are properly routed and attach retainers to the vehicle.
3. Connect the EVAP purge line onto the EVAP canister.
4. Lower the vehicle from the hoist.
5. Connect the fuel feed line to fuel rail and install the safety clip.
6. Connect the negative battery terminal.
7. Prime the fuel system.
1. Cycle the ignition ON for 5 seconds and then OFF for 10 seconds.
2. Repeat step 7.1 twice.
3. Crank the engine until it starts. The maximum starter motor cranking time is 20 seconds.
4. If the engine does not start, repeat steps 7.1-7.4.
8. Run the engine and check the system for leaks.
