VUE AWD L4-2.2L VIN D (2005)
1.4
Select TRANSMISSION INFORMATION.
1.5
Read calibration I.D. and record this number for use in step 3.
Important:
Before installing new TCM calibration, make sure the Saturn Service Stall System (SSS) version is TIS 9.0 2004 or later.
2.
Program the TCM with new calibration. Refer to the calibration information table and select the appropriate TCM calibration for the application.
Use Saturn Service Stall (SSS) software release TIS 9.0 2004 or higher data CD. For reprogramming procedures, refer to the Service
Programming System (SPS) in the SSS Users Guide.
3.
Raise and support the vehicle. Refer to "Lifting and Jacking the Vehicle" in the General Information section of the appropriate Service Manual or
SI.
4.
Drain and fill transaxle. Refer to steps 5-14 in this bulletin.
5.
Vehicle transaxle fluid should be above ambient air temperatures after performing step 2 of service procedure. With transaxle fluid temperature
above ambient air temperature, remove the lower tube assembly from the transmission. Refer to illustration. Allow the fluid to completely drain. A
normal amount of fluid drained in this manner should be approximately 3.79 L (4.0 qt, 1 gal).
6.
Install the lower tube assembly and add approximately 3.79 L (4.0 qt, 1 gal) of new fluid, P/N 15250985 - gallon, P/N 15234609 - quart, to the
transmission.
Important:
If vehicle is equipped with traction control, turn traction control off.
7.
Start the vehicle and perform the following drive cycle on the hoist. The drive cycle will ensure that the added fluid is properly circulated
throughout the transmission.
7.1.
Operate the vehicle in REVERSE (R) at 30 mph (48 km/h) for 15 seconds.
7.2.
Operate the vehicle in DRIVE (D) at 60 mph (97 km/h) for 15 seconds.
7.3.
Operate the vehicle in REVERSE (R) at 30 mph (48 km/h) for 15 seconds.
7.4.
Operate the vehicle in DRIVE (D) at 60 mph (97 km/h) for 15 seconds.
