VUE AWD L4-2.2L VIN D (2005)
Oil Pressure Sensor: Service and Repair
Engine Oil Pressure Sensor and/or Switch Replacement
Special Tools
J 35749 Oil Pressure Socket
Removal Procedure
1. Turn ignition OFF.
2. Disconnect engine oil pressure (EOP) switch harness connector.
3. Remove the EOP switch using the J 35749.
Installation Procedure
1. Apply RTV sealant (or equivalent) to the EOP switch threads.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the EOP switch.
^
Tighten the engine oil pressure switch to 22 Nm (16 ft. lbs.).
3. Connect the EOP switch harness connector. Push in the connector until a click is heard, then pull back to confirm a positive engagement.
4. Check the oil level and fill if low.
5. Start the engine and check for leaks.