VUE AWD L4-2.2L VIN D (2005)
Oxygen Sensor: Service and Repair
Heated Oxygen Sensor (HO2S) 2 Replacement
HEATED OXYGEN SENSOR (HO2S) 2 REPLACEMENT
TOOLS REQUIRED
J 39194-C O2 Sensor Wrench
REMOVAL PROCEDURE
1. Turn the ignition OFF.
NOTE: The HO2S uses a permanently attached pigtail and connector. This pigtail should not be removed from the HO2S. Damage or removal of the
pigtail or connector could affect proper operation of the sensor.
2. Raise the vehicle.
CAUTION: Ensure that the vehicle is properly supported and squarely positioned. To help avoid personal injury when a vehicle is on a
hoist, provide additional support for the vehicle on the opposite end from which the components are being removed.
3. Disconnect the HO2S-2 harness connector.
4. Remove the HO2S-2 harness clip from the heat shield attachment.
5. Use a liquid penetrate before removing the sensor.
6. Remove the HO2S-2 using the J 39194-C, or equivalent.
NOTE: Refer to Heated Oxygen and Oxygen Sensor Notice in Service Precautions.
INSTALLATION PROCEDURE