VUE AWD L4-2.2L VIN D (2005)
5. Insert the J 44810 as shown and rotate the switch until the tool drops into position. The switch is aligned when the pin on the tool drops into the
hole on the transaxle range switch.
6. Notice: Refer to Fastener Notice in Service Precautions.
^
Tighten the transaxle range switch bolts.
^
Tighten the transaxle range switch bolts to 11 Nm (8 ft. lbs.).
7. Remove the alignment tool.
8. Install the transaxle range switch lever and nut.
^
Tighten the transaxle range switch lever nut to 16 Nm (12 ft. lbs.).
9. Install the control cable assembly to transaxle range switch lever.
10. After adjusting the switch, verify the engine only starts in (P) Park or (N) Neutral. Using the scan tool, monitor the TR Sw. to verify the selected
