VUE AWD L4-2.2L VIN D (2005)
15. Remove the CPA from the seat belt pretensioner - LF connector.
16. Disconnect the seat belt pretensioner - LF connector.
ENABLING PROCEDURE
1. Remove the key from the ignition switch.
2. To enable the roof rail module - left, perform steps 3-8. To enable both the roof rail module - left and the seat belt pretensioner - LF, continue to
step 3.
3. Connect the roof rail module - left connector to the vehicle harness connector.
4. Install the CPA to the roof rail module - left connector.
5. Install the rear coat hooks.
6. Install the rear headliner push-in retainers.
7. Install both the left and right rear corner garnish moldings.
8. Install the upper rear window molding.
9. Connect the seat belt pretensioner - LF connector and install the CPA.
10. Install the lower center pillar trim.
11. Install the AIR BAG fuse into the body control module fuse center.
12. Install the body control module fuse center cover.
13. Use caution while reaching in and turn the ignition switch to the ON position.The AIR BAG indicator will flash then turn OFF.
14. Perform the Diagnostic System Check if the AIR BAG warning indicator does not operate as described. Refer to Diagnostic System Check -
Vehicle in Vehicle DTC Information.
