VUE AWD L4-2.2L VIN D (2005)
33. Route the deployment harness out of the driver side of the vehicle.
34. Disconnect the I/P module yellow harness connector from the vehicle harness connector.
35. Cut the yellow harness connector out of the vehicle, leaving at least 16 cm (6 in) of wire at the connector.
IMPORTANT: If the vehicle is equipped with dual stage air bags the steering wheel module and I/P module will each have 4 wires. Refer to SIR
Connector End Views for determining high and low circuits.
36. Strip 13 mm (0.5 in) of insulation from each of the connector wire leads.