VUE AWD L4-2.2L VIN D (2005)
1. Connect the horn switch connector.
2. Connect the inflatable restraint connectors.
IMPORTANT: This vehicle is equipped with dual stage air bags, you will find 2 connectors. Match the right color connector to the right color
opening in the module.
3. Align the retaining pins on the inflatable restraint module with the steering wheel.
4. Push the inflatable restraint module to secure.
5. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in Restraint Systems.
6. After replacing the module, deploy the old module before disposal. If the module was replaced under warranty, fully deploy and dispose of the
module after the required retention period. Refer to Inflator Module Handling and Scrapping for proper disposal.
Instrument Panel Module Replacement
INFLATABLE RESTRAINT INSTRUMENT PANEL MODULE REPLACEMENT
REMOVAL PROCEDURE
1. Disable the SIR system. Refer to SIR Disabling and Enabling Zone 5.
CAUTION:
-
Refer to SIR Inflator Module Handling and Storage Caution in Service Precautions.
-
A deployed dual stage inflator module will look the same whether one or both stages were used. Always assume a deployed dual stage
inflator module has an active stage 2. Improper handling or servicing can activate the inflator module and cause personal injury.
2. Remove the I/P top cover.
3. Remove the radio.
4. Remove the fastener from the passenger side air outlet duct.
5. Remove the air outlet duct.
6. Reach through the radio and the air outlet duct areas to access the fasteners. Remove the fasteners securing the SIR to the I/P beam.
7. Unsnap the module from the I/P carrier retainers.
8. Remove the module from the vehicle.
INSTALLATION PROCEDURE
