VUE AWD L4-2.2L VIN D (2005)
10. Connect the seat belt pretensioner - RF connector and install the CPA.
11. Install the lower center pillar trim.
12. Connect the roof rail module - right connector to the vehicle harness connector.
13. Install the CPA to the roof rail module - right connector.
14. Install the rear coat hooks.
15. Install the rear headliner push-in retainers.
16. Install both the left and right rear corner garnish moldings.
17. Install the upper rear window molding.
18. Install the AIR BAG fuse into the body control module fuse center.
19. Install the body control module fuse center cover.
20. Use caution while reaching in and turn the ignition switch to the ON position.The AIR BAG indicator will flash then turn OFF.
21. Perform the Diagnostic System Check if the AIR BAG warning indicator does not operate as described. Refer to Diagnostic System Check -
Vehicle in Vehicle DTC Information.
