VUE AWD L4-2.2L VIN D (2005)
Front Steering Knuckle: Service and Repair
The content of this article reflects the changes identified in TSB Bulletin No. #05-03-08-017 dated December 06, 2005.
SUBJECT: Steering Linkage Outer Tie Rod-to-Steering Knuckle Nut Torque
Steering Knuckle Replacement
^
Tools Required
-
J 43828 Ball Joint Remover
-
J 44015 Steering Linkage Installer
-
SA9110OC Tie Rod Separator
-
SA9140E Torque Angle Gage
Removal Procedure
1. Raise and support the vehicle.
2. Remove the tire and wheel.
Important: Do not allow the stabilizer link ball stud to rotate while removing the link nut.
3. Disconnect the stabilizer link from the strut assembly.
4. Loosen the steering knuckle to strut bolts and nuts.
