VUE AWD L4-2.2L VIN D (2005)
9. Connect the outer tie rod end to the steering knuckle.
10. Use the J 44015 to seat the ball stud taper to 40 Nm (30 ft. lbs.).
11. Remove the J 44015.
12. Install a new tie rod retention nut.
-
Tighten the steering linkage outer tie rod-to-steering knuckle nut to 25 Nm (18 lb ft) Plus 90 degrees.
Important: Do not allow the stabilizer link ball stud to rotate while installing the link nut.
13. Connect the stabilizer link to the strut assembly.
^
Tighten the nut to 65 Nm (48 ft. lbs.).
14. Install the tire and wheel.
15. Lower the vehicle.
16. Perform a wheel alignment.