VUE AWD L4-2.2L VIN D (2005)
2. Install the park/neutral position switch (42) gently over the manual shift shaft (932), and install the M 6 x 1.0 x 16 mm flanged bolt/screws loosely
into the transmission case housing.
3. Install a new lock washer over the manual shift shaft while aligning the projection/indicator point of the lock washer with the positioning line on
the park/neutral position switch, and install the 16 mm locknut.
4. Notice: Refer to Fastener Notice in Service Precautions.
Push the 16 mm locknut against the transmission housing to seat the park/neutral position switch into the manual shift shaft, and tighten the 16 mm
locknut while holding the manual shift shaft (932) with an adjustable wrench, and then bend the lock tabs of the lock washer (46) against the 16
mm lock nut.
^
Tighten the 16 mm locknut to 12 Nm (8.7 ft. lbs.).
5. Tighten the park/neutral position switch flanged bolt/screws to secure the park/neutral position switch to the transmission case housing.
^
Tighten the 2 M 6 x 1.0 x 16 mm flanged bolt/screws to 12 Nm (8.7 ft. lbs.).
