VUE AWD L4-2.2L VIN D (2005)
1. Important: Do not damage the pushrod boot when sliding it through the front of the dash.
Uncap the fluid reservoir and hydraulic lines.
2. Notice: Refer to Fastener Notice in Service Precautions.
Slide the clutch fluid reservoir into the mounting slot and install the clutch master cylinder mounting nuts.
^
Tighten the nuts to 23 Nm (17 ft. lbs.).
3. Install the clutch master cylinder pushrod to the clutch pedal assembly, 1st design.
4. Install the clutch pedal retainer.
5. Install the clutch master cylinder pushrod to the clutch pedal assembly, 2nd design.
