VUE AWD L4-2.2L VIN D (2005)
Control Module: Testing and Inspection
Transmission Control Module Reprogramming Procedures
TCM Programming Procedures
1. The transmission control module (TCM) must be programmed with the proper software/calibrations. Ensure that the following conditions exist in
order to prepare for TCM programming:
^
The battery is fully charged.
^
The ignition switch is in the RUN position.
^
The Techline equipment cable connection at the data link connector (DLC) is secure.
2. Program the TCM using the latest software matching the vehicle. Refer to up-to-date Techline equipment user instructions.
3. If the TCM fails to program, proceed as follows:
^
Ensure that the TCM connection is OK.
^
Inspect the Techline equipment for the latest software version.
^
Attempt to program the TCM. If the TCM still cannot be programmed properly, replace the TCM.
