VUE AWD L4-2.2L VIN D (2005)
10. Install the battery tray bracket.
11. Position the battery tray bracket and tighten the screws.
^
Tighten the battery tray bracket screws to 16 Nm (12 ft. lbs.).
12. Install the battery.
13. After adjusting the switch, verify the engine only starts in (P) Park or (N) Neutral. Using the scan tool, monitor the TR Sw. to verify the selected
position matches the scan tool. Move the selector through all positions. If the engine starts in any other position, readjust the switch.
Installation Procedure
(USING NEW SWITCH)
1. Make sure the transaxle manual shaft is in (N) Neutral position.
2. Align the flats on the transaxle shift shaft with the flats on the transaxle range switch and install the switch.
3. Tighten the transaxle range switch bolts.
^
Tighten the transaxle range switch bolts to 11 Nm (8 ft. lbs.).
